
It is easy to assume that making the switch to an electric vehicle (EV) means saying goodbye to traditional automotive headaches – like dead batteries. After all, if an EV carries its own massive high-voltage battery pack beneath the floor, how could it not run?
Nonetheless, service centers and roadside assistance crews routinely respond to calls involving EVs stranded by dead batteries. Oftentimes, the reason lies in an overlooked but necessary component: the traditional 12-volt auxiliary battery. Just as with gasoline-powered cars, an EV simply will not run if its 12-volt system is not operating properly.
EVs Run on Dual Power Systems
An EV obviously relies on electricity to run. But it is not a single electrical system that powers your typical electric vehicle. Rather, there are two distinct electrical systems, both of which need separate voltages:
-
High-Voltage System – The high-voltage system typically has an output of 400-800 volts. It powers the electric drive motors, climate control system, and cabin heating.
-
Low-Voltage System – The low-voltage system has an output of 12 volts. It powers essential vehicle electronics, including door locks, exterior lighting, power steering, driver assist, infotainment systems, etc.
The most important thing to note is that the two systems are completely separated from one another. That means the high-voltage battery pack is isolated from the rest of the vehicle when it is parked or powered down. In either state, high-voltage mechanical switches inside the main battery enclosure remain open. This prevents current from flowing through the vehicle while it’s idle.
When you are ready to drive, it is the 12-volt battery that powers up the onboard computers and energizes relay coils. The mechanical switches close, and the car comes to life. But if the 12-volt battery dies, those switches cannot be closed. As such, the high-voltage battery pack cannot engage, leaving the car bricked.
Portable Jump Starters and EVs
Before moving on, it’s worth noting that it is possible to get a dead EV working again using a portable jump starter. The same portable unit – like a Booster PAC jump starter from Clore Automotive – can rescue an EV with a dead 12-volt battery. Caution is still advised.
Using a jump starter with a dead EV works much the same way as using it with a gasoline-powered vehicle, but owners should always consult their manuals before doing anything. It’s also a bad idea to attempt to rescue an EV with a dead 12-volt battery using another EV or a hybrid vehicle. Connecting two EVs or an EV and a hybrid could lead to catastrophic damage.
Why 12-volt EV Batteries Fail Unexpectedly
As for why 12-volt EV batteries fail unexpectedly, there isn’t just one culprit. A dead battery could fail to do its job for a number of reasons:
-
Continuous Parasitic Draw – Modern EVs are essentially computers on wheels. Many of their components continually draw from the battery, even when the vehicle is not running.
-
Converter Cycles – Because EVs lack alternators, they rely on converters to maintain auxiliary batteries. An EV that sits parked for an extended period of time may stop cycling the converter, thus allowing the 12-volt battery to die.
-
Deep Discharge – An EV’s auxiliary battery is subject to the same internal plate degradation over time. This is due to continuous deep-discharge cycles that never allow the battery to fully recharge.
Clore Automotive explains that good battery maintenance protocols will extend the life of an EV’s 12-volt battery. However, they caution against using the same maintenance practices applied to gasoline-powered cars and their batteries. It is important that EV owners read their manuals carefully and ask the pros questions before doing anything.